An Introduction to Hardwood Floor Refinishing

Hardwood Floor Refinishing Schaumburg IL
There comes an occasion in the life of a wooden floor where its shine will fade and it will no longer look new. You may find that waxing your floors is sufficient to get them looking great again; however, that you will find to learn hardwood floor refinishing if you would like them to look like they did when you first had them installed. Be aware of the fact that this is pretty hard work though, so many people prefer to hire a professional. In case you are the do it yourself type though you will probably enjoy dealing with a project like this.

Hardwood Floor Refinishing Schaumburg IL
Before you begin to refinish hardwood flooring at home, first make sure that it's the right course of action. It is a great way to increase the worth of your home, but isn't always necessary. For example, if the floor has only light scratches or perhaps a lackluster surface, it could simply need a top coat of finish to have it looking new again. Another possibility that the floor may be far too late for even hardwood floor refinishing to be enough. In these cases whole planks in your floor may need replacing. When the boards seem soft, spongy, sags or are warped, then consider simply getting them replaced.

If the problem with your floor is scratches and dings, then hardwood floor refinishing is most likely a suitable treatment. However, understand that a floor may only be refinished a few times as it takes a fair level of sanding, each time taking off quite a bit of wood. In order to get advisable of how much wood remains inside your flooring, check around the sides. Also keep in mind that maple floors are particularly hard to deal with, so consider hiring a professional in this case.

Among the first steps to refinish hardwood floors is sanding, but before you start it is a good idea to first fill in the gaps. These is going to be easier to spot in winter than in summer, but when they are visible in summer you realize they should definitely be filled. When you're ready to begin sanding, you'll need the following tools: drum sander, floor edger, buffer, palm sander, and a shop vacuum. This can be a noisy job, so you should always be wearing ear protection. Finally, make sure you not let the sander sit in a single spot as it only requires a second to cause damage.

After the sanding is finished it is time to apply your stain. If you're unsure about what type or shade of stain to use, you should consider asking the professional who installed your floors. When applying, use the grain in 5 foot wide sections along the entire width with the room. Once applied it will need roughly 24 hours in order to dry. It's not always a straightforward job, but you will realize that hardwood floor refinishing may be an extremely rewarding job and definately will save you some money as well.